Operation Manual Wall-O-Lite DMX
Dimmer level - Lamp response Sliding the fader on the dimmer board from 0 ~ 100 controls the number of lamps that are on within a fixture. Note: t
For example, if the DMX Wall-O-Lite base address is set at 001, the configuration below will provide eight lamps individually addressable through DM
12 KAS-W48-1 KAS-W48-2 KAS-48 Part Description Di
Environmental: Disposal of Old Electrical & Electronic Equipment. 13
CFX-W48-X120………Wall-O-Lite Fixture, DMX 120 VAC CFX-W48-X230………Wall-O-Lite Fixture,
Insert lamps into both lamp holders. Twist ¼ turn to make electrical contact. • Align the two fixed pins of the
The gel frame is secured to the fixture by 4 spring-loaded pins. Align the pins of the gel frame with the oval receptacle holes on the ed
5 The Wall-O-Lite can be mounted to a Junior Combo stand or hung from a pipe hanger. The Junior Mount that is includ
6 A D E C B A) Manual Selector Dial: Turns lamps on and off manually with
Provide 120 Volt AC primary power. Do not dim the fixture through a dimming circuit. If powering the fixtures through a dimmer board,
DMX Addressing Prior to hanging any instruments set the DMX address of each Fixture. Push the tabs above or below the number window to set the
DMX Cables The Fixture uses five-pin XLR male and female connectors to receive DMX signals from the Dimmer Board and jumper the Fixtures in a series
Kommentare zu diesen Handbüchern